Share on

Loading a Reefer Container with Frozen Pangasius: 20 ft or 40 ft, Temperature, Seals and VGM

News

CN

Tbes Editorial Team

In short: most frozen pangasius fillet ships in a 40 ft reefer, and a 20 ft reefer suits smaller or mixed orders. The container does not freeze fish. It holds a temperature the product already has. So the order of work is: freeze and hold the cartons at −18 °C or colder, inspect and pre-cool the container, load below the red line without blocking the air, record the temperature, seal, and declare the verified gross mass.

This guide follows one container from the cold store to the seal. It pairs with our comparison of FOB, CFR and CIF for a reefer container and our guide to pre-shipment inspection.

Which size: 20 ft or 40 ft?

A 40 ft reefer commonly takes about 19 to 25 tonnes of cartoned fillet, depending on carton dimensions, whether pallets are used, and the weight limits on the road and at the port. A 20 ft reefer takes less than half as many cartons because its internal volume is well under half. Treat these as planning figures and confirm the number with the forwarder against your actual carton size. As an arithmetic example only, 24 tonnes of 10 kg cartons is 2,400 cartons.

Choosing a reefer size for frozen pangasius
ContainerTypical usePlanning note
20 ft reeferSmaller orders, trial shipments, mixed productsFewer cartons, and freight per tonne is usually higher
40 ft reefer (high cube)Full orders of one or two productsCheck pallet use and weight limits at origin and destination
Mixed containerSeveral products in one boxOne set point for all products, so confirm each product accepts it

What temperature should the container run at?

Frozen fish is kept at −18 °C or colder. EU rules on quick-frozen foods set −18 °C at all points in the product, with short rises of up to 3 °C tolerated during transport. The set point is written into the contract and the booking, most often −18 °C or lower. A reefer unit maintains temperature. It is not built to pull warm product down. Cartons should therefore reach the container already hard frozen, and the plant should record the core temperature at loading.

Preparing and loading the container

Before stuffing, the container goes through a pre-trip inspection: unit running, floor and drains clean, no odour, door seals intact, and the box pre-cooled to the set point. Cartons then move fast from the cold store to the container through a covered or cooled dock, so the product does not warm while it waits.

Load only up to the red line marked on the container wall. Cargo above that line blocks the air that flows along the ceiling and down through the floor. Keep the floor channels open, leave a gap at the door end, and do not stack cartons against the return air opening. Palletised loads and floor loads both work. Agree which one is used beforehand, because it changes the carton count.

Two port workers inspecting a reefer container lifted by a reach stacker in a container yard

Records, seals and verified gross mass

Place a temperature data logger in the load, or ask the line to download the unit's record on arrival. Photograph the empty container before stuffing and the loading at each stage. The container is sealed at the plant, and the seal number goes onto the bill of lading, the packing list and the export documents. Since the SOLAS amendment that took effect in 2016, the shipper must also give the carrier the verified gross mass of the packed container before it is loaded on board. Weigh the container or use an approved calculation method, and send the figure before the cut-off.

Loading checklist for one reefer container
StepWhat to recordWho
Pre-trip inspectionUnit working, set point, pre-cool timeDepot or forwarder, checked by the plant
Core temperature at loadingTemperature of sample cartons or each palletPlant QC
Load patternPallets or floor load, carton count, red line respectedPlant
Data loggerLogger serial number and position in the loadPlant, with the download sent to the buyer
SealSeal number on every documentPlant
Verified gross massGross mass and the method usedShipper

Common questions

Does the carton count change with the Incoterm?

No. The Incoterm decides who pays and who carries risk at each stage. It does not change how many cartons fit in the box.

Can a reefer correct a warm load?

Not reliably. The unit holds temperature. If product enters warm, the load can end up outside specification even though the unit ran correctly, so core temperature is checked before loading.

Who should hold the data logger record?

Agree it in the order. Many buyers ask for the download on arrival so it can be read together with the delivery inspection.

Related reading

From RFQ to first container covers the stages before loading, and trim levels and size grading covers what goes into the cartons.

Let's Talk

Our team is available to answer your questions. Please fill out the form and we'll be in touch shortly.

*Please share the details of your request, and if applicable, the specific product you're interested in.

Email us

export@tbesfood.com

Call or WhatsApp

+84 932 072 978

TBESFOOD COMPANY LIMITED

A member of TBES Group

Head Office: 2nd Floor, 81 Cach Mang Thang 8 Street, Ben Thanh Ward, Ho Chi Minh City, Vietnam

Branch: 62/29C Lam Van Ben Street, Tan Hung Ward, Ho Chi Minh City, Vietnam

Factory: Lot C1.1, Cau Cang Phuoc Dong Industrial Zone, Hamlet 5, Phuoc Dong Commune, Can Duoc District, Long An Province

Lao Factory: Lao Yeast Factory, Ban Naphasouk, Xaythany District, Vientiane Capital, Lao PDR

TBES FOOD PTE. LTD.

Singapore Address: 470 North Bridge Road, #05-12, Bugis Cube, Singapore 188735

Sister brands: TbesAgri frozen fruit · TBESBY brewer's yeast · Lao Yeast Factory industrial ethanol

© 2016–2026 TBESFOOD COMPANY LIMITED. All rights reserved.

EspañolPrivacyCookie settings
FacebookEmailWhatsApp

TBESFOOD COMPANY LIMITED, a member of TBES Group