Share on

Shrimp Pieces and Broken Grades for Processors: A Specification Framework

News

CN

Tbes Editorial Team

In short

A contract for shrimp pieces or broken grades needs three definitions: what counts as a piece (its minimum size), what share of the pack may be pieces (by weight or by count), and which test method measures it. Take the wording from the Codex text or from your own contract. This post sets no values.

What are shrimp pieces and broken grades?

Pieces and broken shrimp are shrimp that are no longer whole. They arise in peeling, cooking, freezing and handling. Processors buy them for uses where the shape of a single shrimp does not matter. An industry association table places the smallest shrimp sizes in fillings, pastes and similar uses, and pieces fit the same logic.

Buyers and sellers use different names for these grades. The words pieces, broken, bits and tails do not mean the same thing in every contract. We did not find a single trade term with a fixed size. The safe course is to define the grade in the document, by size and by method, instead of relying on the name.

Which text should define a piece or a broken shrimp?

Codex Alimentarius publishes the Standard for Quick Frozen Shrimps or Prawns (CXS 92). It applies to quick frozen raw or partially or fully cooked shrimps or prawns, peeled or unpeeled, and it sets how the count is determined on the de-glazed weight. Read the current English text for the exact wording of any piece or defect criteria. Other Codex and national texts exist for other product forms, such as canned shrimp, and they may define broken shrimp in their own terms. Check that the standard you cite covers frozen peeled product.

We state no definitions here because the wording of each text, its clause number and its scope all matter. Write the contract so that it names one document, one clause and one edition. If the buyer and the seller want a different definition, write it in full in the contract and say that it overrides the standard.

What should the contract define?

Contract items for a pieces or broken grade
ItemWhat to defineQuestion for the supplier
Whole shrimpForm, count band and condition that make a shrimp wholeWhich count band applies to the whole shrimp in the pack?
PieceMinimum size, as a fraction of a whole shrimp or as a weightWhich definition do you use, and from which document?
BrokenHow a broken shrimp differs from a pieceIs broken a separate class from pieces?
Share of piecesPercentage by weight or by count, with a limitWhich basis do your records use?
Weight basisNet weight without glaze, drainedHow is glaze removed before sorting?
Test methodSample size, thaw method, sorting, weighingCan you send your written method?
RemedyWhat happens when a lot is outside the limitWhat claim window do you accept?

On the weight basis, glaze changes every percentage you calculate. Our guide on how EU buyers check glaze explains why the net weight should be stated without glaze. For pieces, state the glaze declared on the pack and the net weight without glaze, and sort only after the glaze is gone.

How do you measure the percentage of pieces?

A measurement is only useful if both parties repeat it the same way. A workable outline, to be replaced by the method in your contract, is the following.

  1. Draw the sample from the cartons set by the sampling plan, and record the lot code and carton numbers.
  2. Thaw by the agreed method, remove the glaze and drain for the agreed time.
  3. Weigh the drained sample. This is the total net weight.
  4. Sort by hand into whole shrimp, pieces and broken shrimp, using the definitions written in the contract.
  5. Weigh each fraction. Divide the piece fraction by the total net weight and multiply by 100.
  6. Photograph the sorted fractions and keep the record with the lot code.

Illustration: a drained sample weighs 1,000 g. The sorted pieces weigh 80 g. The share of pieces is 80 divided by 1,000, multiplied by 100, which is 8 percent. The figure is an arithmetic example. It is not a recommended limit.

How do pieces change yield for a processor?

One steaming trial on vannamei, published in a conference series, reported a yield of 61.92 percent from whole shrimp to completely peeled raw shrimp, and a cooking loss of 7.24 percent after 30 minutes of steaming at 100 °C. It is a single trial with one method, so use it as an indication of what to measure and not as a planning figure.

A processor can apply the same logic to a pieces grade. Run your own line trial with the lot. Record the weight in, the weight after thawing and draining, the weight after any cooking step and the weight of the finished product. Repeat for a pack with a low share of pieces and a pack with a higher share, and compare the results. A filling or a paste may tolerate more pieces than a product sold with a visible shrimp, so set the limit by the end use.

Which checks and documents should travel with the specification?

  • A signed specification sheet that names the grade, the definitions, the limit and the test method.
  • A pre-shipment inspection that checks the share of pieces as well as count and weight. See what to check before the container is sealed.
  • A retained sample from each lot, kept by both parties for the claim period.
  • A named laboratory or inspector for disputes, and the rule for splitting its cost.
  • For further processed lines, the form rules in our OEM specification guide for value-added shrimp.

This is general information. Test methods and labelling rules differ by market, so confirm them with your laboratory and the competent authority at the destination. We have no source for the share of pieces that is normal in a pack, and we do not suggest one. Ask us for the current specification of a pieces grade.

FAQ

Is a piece the same as a broken shrimp?

Not always. Some texts treat them as separate classes and others use the words loosely. The definitions in the standard you cite, or in your contract, decide. Write both terms into the specification and define each one by size and by test method.

Should the percentage of pieces be by weight or by count?

Weight is easier to repeat, because a scale gives the same result for both parties. Count is harder because the parties may count a damaged shrimp differently. Whichever you choose, state it, state the glaze basis and say whether the sample is drained.

What should I ask a supplier about shrimp pieces?

Ask which document defines a piece, what the minimum size is, how the share of pieces is measured, on which weight basis, and what the remedy is when a lot falls outside the limit. Ask for the written test method and for a photograph of a sorted sample.

Sources

Send the specification you need to TBESFOOD, with product, form, count band, packing and destination, and include the piece definition and test method you use. We will reply with a quotation and a timeline.

Let's Talk

Our team is available to answer your questions. Please fill out the form and we'll be in touch shortly.

*Please share the details of your request, and if applicable, the specific product you're interested in.

Email us

export@tbesfood.com

Call or WhatsApp

+84 932 072 978

TBESFOOD COMPANY LIMITED

A member of TBES Group

Head Office: 2nd Floor, 81 Cach Mang Thang 8 Street, Ben Thanh Ward, Ho Chi Minh City, Vietnam

Branch: 62/29C Lam Van Ben Street, Tan Hung Ward, Ho Chi Minh City, Vietnam

Factory: Lot C1.1, Cau Cang Phuoc Dong Industrial Zone, Hamlet 5, Phuoc Dong Commune, Can Duoc District, Long An Province

Lao Factory: Lao Yeast Factory, Ban Naphasouk, Xaythany District, Vientiane Capital, Lao PDR

TBES FOOD PTE. LTD.

Singapore Address: 470 North Bridge Road, #05-12, Bugis Cube, Singapore 188735

Sister brands: TbesAgri frozen fruit · TBESBY brewer's yeast · Lao Yeast Factory industrial ethanol

© 2016–2026 TBESFOOD COMPANY LIMITED. All rights reserved.

EspañolPrivacyCookie settings
FacebookEmailWhatsApp

TBESFOOD COMPANY LIMITED, a member of TBES Group